NetUpdater v1.0.1 (Windows)

PC Minimum System Requirements

  • Windows XP Home/Professional (32-bit) with Service Pack 2,
    Windows Vista (32/64 bit), and Windows 7 (32/64 bit)
  • 1GHz processor
  • 1GB of memory
  • Available USB port

Usage

Updating your firmware requires the RP to perform a factory reset to complete.  A factory reset will erase all user presets from memory.  It is recommended that you backup all your presets using the X-Edit Editor/Librarian backup utility before starting the update procedure. 

  1. Using the NetUpdater application requires being connected to the internet. If you are not connected, you should connect now.
  2. Connect power to your DigiTech USB device and then connect a USB cable from the DigiTech USB device to an available USB port on your computer.
  3. Launch the NetUpdater.exe application that was downloaded by double-clicking its icon.
  4. Follow the instructions outlined in the updater to update your product's firmware.
  5. When the update has finished, close the NetUpdater application by clicking the Done button.

Once the updater has finished, a Factory Reset will automatically take place erasing all User presets. You will then need to calibrate your expression pedal as follows:

  1. When the Display prompts you with TOE DN, rock the Expression Pedal forward (toe down) and press either Footswitch.
  2. When the Display prompts you with TOE UP, rock the Expression Pedal back (toe up) and press either Footswitch.
  3. The Display now prompts you to calibrate the V-Switch sensitivity (VSWxxx), where XXX is the current V-Switch threshold. Rock the Expression Pedal forward and press firmly on the toe once to turn the V-Switch on (WAH ON), and again to turn the V-Switch off (WAHOFF).
  4. If the V-Switch is too sensitive, press the right Up Footswitch to raise the threshold (range is 0-200). Keep testing the V-Switch sensitivity and adjust the threshold until it only engages when you want it to (too sensitive a setting will lead to the V-Switch falsely triggering on or off when using the Expression Pedal).
  1. When the V-Switch sensitivity is set to your satisfaction, press both Up/Down Footswitches simultaneously to exit.

Related Products

Rp250 top thumb

RP250

Modeling Guitar Processor
Rp1000 top thumb

RP1000

Multi-Effects Switching System & USB Recording Interface
Rp350 top thumb

RP350

Modeling Guitar Processor
Rp150 top thumb

RP150

Modeling Guitar Processor
Rp155 top thumb

RP155

Guitar Multi-Effects & USB Recording Interface
Rp255 top thumb

RP255

Guitar Multi-Effects & USB Recording Interface
Rp355 top thumb

RP355

Guitar Multi-Effects & USB Recording Interface
Rp500 top thumb

RP500

Multi-Effects Switching System & USB Recording Interface
Bp355 front thumb

BP355

Bass Multi-Effects & USB Recording Interface
Gsp1101 front thumb

GSP1101

Multi-Effects Preamp & Processor